Advertisement
Amulet High Definition Television Receiver User's Guide
Part 68 - Compliance Registration
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. A label on the bottom of this equipment contains,
among other information, the Ringer Equivalence Number (REN) and the
product identifier. For products approved after July 23, 2001 the product
identifier is in the format US:AAAEQ##TXXXX. The digits represented by ##
are the REN without a decimal point (e.g. 03 is a REN of 0.3). The REN is
used to determine the number of devices that may be connected to a
telephone line. For earlier products, the REN is separately shown on the
label. If requested, this number must be provided to the telephone company.
Excessive RENs on a telephone line may result in the devices not ringing in
response to an incoming call. In most, but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may
be connected to a line, as determined by the total RENs, contact the local
telephone company. This equipment is designed to connect to the telephone
network or premises wiring using a compatible modular jack that is Part 68
compliant. An FCC compliant telephone cord and modular plug is provided
with the equipment. If this terminal equipment causes harm to the telephone
network, the telephone company may request you to disconnect the
equipment until the problem is resolved. The telephone company will notify
you in advance if temporary discontinuance of service is required. If advance
notification is not practical, the telephone company will notify you as soon as
possible. You will be advised of your right to file a complaint with the FCC if
you believe such action is necessary. If you experience trouble with this
equipment, do not try to repair the equipment yourself. The equipment cannot
be repaired in the field. Contact your ISP for further instructions. The
telephone company may make changes to their facilities, equipment,
operations, or procedures that could affect the operation of this equipment. If
this happens, the telephone company will provide advance notice in order for
you to make the modifications necessary to maintain uninterrupted service. If
your home has specially wired alarm equipment connected to the telephone
line, ensure that the installation of this equipment does not disable your alarm
equipment. If you have questions about what will disable alarm equipment,
consult your telephone company or a qualified installer. This equipment
cannot be used on public coin phone service provided by the telephone
company. Connection of this equipment to party line service is subject to
state tariffs.
Declaration of Conformity (Europe Only)
This product is in conformity with the Council Directives:
EMC Directive 89/336/EEC
•
Low voltage Directive 73/23/EEC
•
Entone products are designed and tested to meet IEC00065, the standard for
the Safety of Information Technology Equipment. This is the international
standard for these types of products to reduce the risk of product damage
and of personal injury. The standard protects against the following hazards:
Electric shock
•
Hazardous voltage levels
•
Fire — Overload, temperature, material flammability
•
Energy — Circuit with high energy or potential as burn hazards
•
Heat — Accessible part of the product at high temperatures
•
Radiation
•
Noise
•
Copyright © © © © 2007 Entone, Inc. All rights reserved
.
Advertisement
