Advertisement
Amulet High Definition Television Receiver User's Guide
1.
Use the coaxial cable that comes packaged with Amulet to connect your TV's antenna input to the
Amulet's "RF TV".
2.
Tune your TV to channel 10 to view the output.
NOTE:
In the RF TV, it is factory set to use channel 10.
To set RF TV to another channel ID, please refer to section Setting Channel ID.
Figure 4-1 Connecting TV using Coaxial Cable
In order for the Amulet to feed video signal to TV using RF TV, your TV must be configured to receive signal
from CATV rather than from the antenna.
Most TVs use either a physical switch located on the rear of the TV or with on-screen programming to
configure to use CATV. Consult your TV owner's manual for instruction if required.
Copyright © © © © 2007 Entone, Inc. All rights reserved
.
Advertisement
