Table of Contents
Advertisement
Cleaning the air cooler
3-4 times a year or if Filter flashes
continuously
after the fluff filter has
been cleaned.
1. Leave the dryer to cool down.
2. Residual water may escape,
place an absorbent
cloth under
the maintenance
flap.
3. Unlock the maintenance
flap.
4. Completely
open maintenance
flap.
5. Turn both locking levers
towards
each other.
6. Remove the front insert,
[-_Do
not damage the air cooler!
Clean with warm water only;
do not use hard/sharp-edged
objects!
8. Clean the air cooler completely,
drain thoroughly.
9. Clean the seals.
10. Re-insert the air cooler, making
sure that the air cooler handle is
oriented to the bottom
of the
unit as shown in the illustration
above.
11. Turn both locking levers ti lock
the air cooler in place.
12. Close the maintenance
flap
until it locks into position.
Cleaning the moisture
sensor
Occasionally
the moisture
sensor
has to be cleaned because a fine
layer of transparent
buildup is
deposited
on the sensors.
This deposit can easily be removed
by wiping the sensors (the two bars
next to the lint filter) with a cloth and
a little white vinegar.
Use white vinegar only!
Clean the moisture
sensor once
a month.
Cleaning
the Lint Filter
Housing
Over time, fluff from the drying
process
collects in the bearing
shield.
7. Pull out the air cooler.
This fluff can be easily removed
using your vacuum
cleaner, at least
once a month.
18
Hide quick links:
Advertisement
Table of Contents
