Cleaning And Care; Cleaning The Dryer; Cleaning The Lint Filter; Cleaning The Air Cooler - Bosch WTE86300US Operating, Care And Installation Instructions Manual

Cleaning and
care
Cleaning the dryer
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
Incorrect cleaning may damage
the dryer. Do not spray with
a water jet. Do not use scouring
agents or all-purpose cleaners.
Do not use steam cleaners.
Wipe the housing and fascia with
a soft cloth and soapy water only.
Wipe the drum, door seal and inside
of the door with a damp cloth only.
Cleaning the lint filter
A dirty filter extends the drying time
and increases energy consumption.
The filter should be cleaned before
and after each drying process,
however at the latest when the
"Filter" indicator light illuminates.
If the "Filter" indicator light
illuminates during a drying program,
clean the filter immediately and
check the condensate hose.
[-i--] The program interrupts
automatically.
1. Switch off the dryer. Program
selector to "Off".
The inside of the door heats up
during the drying process.
2. Open the door.
3. Pull out filter...
4 .... and open.
5. Remove fluff (run hand over
filter).
The filter should be rinsed once
a year under warm running water.
The filter must be dried thoroughly
before being replaced.
6. Close filter and re-insert.
7. Close the door.
Cleaning the air cooler
3-4 times a year or if o (Filter)
flashes continuously after the fluff
filter has been cleaned.
1. Leave the dryer to cool down.
2. Residual water may escape,
place an absorbent cloth under
the maintenance flap.
3. Unlock the maintenance flap.
4. Completely open maintenance
flap.
_iiii_ I i_I
5. Screw both locking levers
towards each other.
6. Pull out the air cooler.
16