Troubleshooting - Bosch WTC82100US/02 Operating & Installation Instructions Manual

Troubleshootin
RISK OF ELECTRICAL SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts
may be carried out by authorized
technicians only.
Before calling customer service,
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or
a repair is required:
1. Set program selector to "Off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see page 20).
Problem
Dryerdoesnotstart.
Start/Stop indicatorlight doesnot
illuminate.
Programhasbeen interrupted.
Filter indicatorlightflashes.
Possiblecause
Powercord notpluggedin at all or not inserted
correctly,
Fuseblownor circuitbreakertripped,
Start/Stop button notpressed,
Doornot closed,
Ambienttemperaturebelow41 °F/5 °C,
Lintfilter dirty,
Faultin programsequence or malfunction.
The room/cabinet i s not adequately ventilated.
Filter indicatorlight illuminates. Condensation o utlet.
Faultin programsequence or malfunction. Start/Stop indicatorlight doesnot
illuminate.Wrinkle block/End indicator
lights.
Degree of dryinghasnot beenreached
or the dryingtime istoo long.
Moisturesensordirty.
Remedialaction
Insertmainplug correctly,
Replace blownfuse or resetcircuit breaker.
PressStart/Stop button.
Closedoor.
Increaseroomtemperature.
Cleanfilter as described on page 17.
Switchoff/switchon again.
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again.Restart p rogram.
Providean adequatesupplyof fresh air.
Switchoff/switchon again.
Checkhosefor condensation o utlet.
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again.Restart p rogram.
Cleanmoisturesensoras described on page18.
Switchoff/switchon again.
Laundry was too wet. Spin laundryat higherspeedin the washing
machine.Switchoff/switchon again.
Unsuitable programselected. Selectprogramwith aid of the programselection
table(seepage 23).Switchoff/switchon again.
Maximum dryingtime was exceeded. Cleanlintfilter (seepage 17).
Checkhosefor condensation o utlet.
Spin laundryat a higherspeedin yourwasher.
Motorlimit temperaturewas exceeded. Switchoff dryer,leaveto cooldownfor 30 min.
Switchon again.Start program.
19