Advertisement
ge.com
SPEED CYCLE
(on some models
CHINA CRYSTAL
GLASSES
(on some models
RINSE ONLY
7.5 gal., 35 min.
This cycle is for everyday dishes and glassware.
7.5 gal., 35 min.
This cgcle is for lightly soiled china and crgstal.
7.5 gal., 35 min.
This cgcle is specifically designed for glasses.
2.5 gal., 10 min.
For rinsing partial loads that will be washed later Do not use detergent with this cgcle.
NOTE; The CHINA CRYSTAL/PLASTICS (some models) selector is a toggle pad, toggle the pod until the
desired cycle is indicated.
NOTE; This dishwasher is equipped with a CleanSensor TM with automatic temperature control, therefore, cycle
length and time may vary depending on soil and temperature conditions.
NOTE; Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for soil
removal and sanitization efficacy.
_]l
Enhancements/Extras
The light above
the selected
pad will be ON to indicate
which ENHANCEMENT/ERTRA
has been selected.
PRE WASH
For use with heavily
soiled and/or
dried-on,
baked-on
soils. This option
MUST be
(on some models)
selected
PRIOR to starting
the cgcle. This option
adds 16 minutes
to the cycle time.
NOTE: Cannot
be selected
with RINSE ONLY cgcle.
HEATED DRY
Shuts off the drying heat option. Dishes air dry naturally
and energg is saved. For
Light OFF
faster air dry, you can prop the door open after the CLEAN light illuminates.
HEATED DRY
Turns the heater on for fast drying. This will extend the time to your wash cgcle bg 8
Light ON
minutes for the SPEED CYCLE and 30 minutes for all other cgcles. NOTE: Cannot be
selected with RINSE ONLY cgcle.
LOCK
You can lock the controls
to prevent
any selections
from being mode.
Or you con lock
the controls
offer you hove started
o cycle.
Children cannot
occidentally
start dishwasher
by touching
pods
with this option
selected.
To unlock the dishwasher
controls,
touch
and hold the HEATED DRY pad for 3 seconds.
The light above the LOCK pad will turn off. To lock the dishwasher,
touch
and hold the
HEATED DRY pad for 3 seconds.
The light above
the LOCK pad will turn on.
ADDED HEAT or
When selected, the cgcle will run longer with heating elements
on to improve
both
EXTRAHOT WASH
wash and dry performance.
NOTE: Cannot be selected with RINSE ONLY cgcle.
(on some models)
DELAY HOURS
You can delag the start of a wash cgcle for up to 9 hours. Touch the DELAY HOURSpad
to choose the number of hours you want to delag the start of the cgcle; then touch
START/RESET.The machine will count down and start automatically
at the correct time.
Touching START/RESETa second time will cancel the DELAY START selection. NOTE: If
you forget to fully close the door, a reminder signal will beep until you do so.
RESET
To change a cgcle after washing starts, touch the START/RESET pad to cancel the
cycle. The START/RESET light will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher
can be reprogrammed and restarted.
Advertisement
