Exhaust Information - GE Spacemaker WSM2700 Installation Instructions Manual

ELECTRICAL
(cont.)
Connecting ApplianceUsing4-Wire Connection
STEP 14 - Remove the terminal block access cover.
STEP 14A - Install U.L. listed 30A, 4-conductor
NEMA 14-30 lype ST closed loop terminal power
cord and the strain relief.
STEP 14B - Connect the green ground wire of the
power cord to the tenninat block bracket with the
green grounding screw.
STEP 14C - Connect the white wire from the power
cord and the green ground wire from the appliance
harness to the center (silver) terminal of the terminal
block.
STEP 14D - Connect the black and red wires from the
power cord to the two outer terminals of the terminal
block.
(continued)
ELECTRICAL (cont.)
GREEN GROUND SILVERTERMINAL
SCREW GREEN
CONDUCTOR
_1_30R)
4*WIRE RECEPTACLE
GREEN GROUND
WIRE
STEP 14E - Check all connection screws for being
securely tightened.
STEP 14F - Re-install the terminal block cover.
CAUTION: Be : electricity is turned OFF at
power source (circuit breaker/fuse box).
STEP 14G - Plug power cord into electrical outlet.
STEP 14H - Return to Step 14 on page 3,
NOTE: THIS APPLIANCE IS NOT APPROVED
FOR 120 VOLT OPERATION.
Exhaust Information
NOTE: Exhausting the dryer to the outside is strongly
recommended to prevent large amounts of moisture
and lint trom being blown into the roor_.
CAUTION, FOR PERSONAL SAFETY:
Use only 4" diameter (minimum) rigid or flexible
metal duct. Do not use plastic flexible duct to
exhaust the dryer. Excessive lint can build up
inside the duct work and create a fire hazard and
restrict air flow.
Restricted air flow will increase drying times.
Do not terminate exhaust in a chimney, any gas
vent, under an enclosed floor (crawl space) or into
an attic. The accumulated tint could create a fire
hazard or moisture could cause damage.
Provide an access for inspection and cleaning of
external exhaust system, especially at the turns.
Inspect and clean at least once a year.
Never terminate the exhaust into a common duct or
plenum with a kitchen exhaust. The combination of
lint and grease could create a fire hazard.
Do not obstruct incoming or exhaust air.
(continued)
PUB. NO. 31-2810 -6- DWG. NO. 131558000 1/95