Advice Regarding The First Wash Cycle - Hotpoint FDEB 31010 EXPERIENCE Instructions For Use Manual

GB
Anti-flooding protection
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water supply
in the event of anomalies or leaks from inside the appliance.
Some models are also equipped with the supplementary safety
device New Acqua Stop
protection even in the event of a supply hose rupture
WARNING: HAZARDOUS VOLTAGE!
Under no circumstance should the water inlet hose be cut as it
contains live electrical parts.
The Company shall not be held responsible for any incidents
that occur if these regulations are not observed.
6
Ensure the drain hose is securely
attached, to prevent it coming away
while the machine is in use and
causing a flood.
Fit hose to waste securely using
a "Jubilee" type clip.
*
*
, which guarantees anti-flooding
.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add only then approximately 1 kg of salt (
chapter Rinse-aid and refined salt
this is normal and is not a cause for concern. Select the water
see chapter Rinse-aid and refined salt
hardness value (
salt has been poured into the machine, the LOW SALT indicator
*
light switches off.
If the salt dispenser is not filled, the water softener and the
heating element may get damaged as a result.
The machine has a buzzer/set of tones
dishwasher model ) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display* provides useful information concerning the
type of wash cycle, wash cycle phase, remaining time,
temperature etc.
*
Only available in selected models.
see
). The water may overflow:
). After the
(depending on the
.