Advertisement
Install
Grease
Cup, and Grease
Bracket
[]
Attach
the Grease Cup Bracket
to the bottom
of the Grease Tray. See Inset
1.
[]
Install
the Grease Cup into the Grease Cup Bracket,
inserting it from the front of the cabinet.
Inset
1
Inset
2
Place LP Cylinder
into the Cabinet
[]
Slide the LP cylinder
tray out of the cabinet
by pulling
the tray latch up in the vertical
position.
Unscrew
the screw on the back of the cylinder tray. Then place the tank onto the sliding
LP cylinder tray. Make
sure the front
of the tank valve faces the front of the cabinet. Tighten
the screw on the back of the
cylinder
tray to secure the LP cylinder.
Slide the LP cylinder
tray back into the cabinet
and lock in place
by pushing
the LP cylinder
tray latch down to a horizontal
position.
Be sure the LP cylinder
is "OFF" by
turning
the hand wheel clockwise until it stops.
(See Inset
1)
[]
Be sure all burner
controls
are turned
to the "OFF" position.
Remove the safety cap from the cylinder
valve. Center the nipple of the regulator
into the cylinder and attach
the regulator
to the LP tank by
turning
the black nut clockwise
until it stops.
Note:
Hand Tighten
Only. Do Not Use A Wrench,
Do Not
Attempt
To Light Your Grill At This Time.
(See Inset
2)
Inset
1
Inset
2
]0
Advertisement
