Kenmore 385.17126690 Service Manual page 28

SEWING MACHINE DIV.20 MODEL 385. 17822490
MECHANICAL ADJUSTMENT
NEEDLE TO SHLIITLETIMING
ADJUST PROCEDURE:
1. REMOVE TESTPIN #_58368 FROM THE NEEDLE CLAMP.
2. REMOVE THE TOP COVER.
3. REMOVE THE SCREW (G) AND TAKE THE BOBBIN WINDER UNIT ( H ) OFF.
4. LOOSEN 2 - SCREWS ( I ) AND ( J ).
5. INSERTTESTPIN #68368 INTO THE NEEDLE CLAMP.
6. TURN THE HANDWHEEL TOWARD YOU UNTIL THE TIP OF THE TEST PIN #68368 ( D )
SLIGHTLY TOUCHES THE RADIAL TIMING GAUGE #68497 ( C ).
7. HOLD THE UPPER SHAFT (K) TO PREVENT ITSTURNING AND TURN THE TIMING GEAR (L)
BACKWARD OR FORWARD UNTIL THE TESTPIN #68368 (D) COMES IN BETWEENTHE 1V#O
ORANGE LINES OF GAUGE :#_:_497 (B).
8. TIGHTEN SETSCREWS ( I ) AND ( J ) SECURELY,
9. PUT THE BOBBIN WINDER UNIT ( H ) BACK AND ADJUST THE MICRO-SWITCH BOBBIN
WINDING.
r (Fo
D
25