Advertisement
HOW TO START
Personal
Injury and Product
Damage
Hazard
• DO NOT plug in if switch is in ON
position.
Personal injury or
damage could result.
• The cord moves rapidly when
rewinding.
Keep children away
and provide a clear path when
rewinding
the cord to prevent
personal
injury.
° DO NOT use outlets above
counters° Damage from cord to
items in surrounding
area
coulidoccur.
I
!
,
iiiiiii
ii
ii ,11
Cord
Rewind
_
iBar
_._
1, Pull cord out of
canister to desired
length. The cord
will not rewind until
the cord rewind
bar is pushed°
NOTE: To reduce the risk of electric shock,
this vacuum cleaner has a polarized
plug;
one blade is wider than the other° This plug
will fit in a polarized outlet only one way° If
the plug does not fit fully in the outlet,
reverse the plugo If it still does not fit, con-
tact a qualified
electrician
to install the prop-
er outlet,, Do not change the plug in any
way,
2, Plug the polarized
power cord into a 120
Volt outlet located
near the floor°
To rewind: Unplug
the cleaner. Hold
the plug while
rewinding to pre-
vent damage or
injury from the
moving cord., Push
cord rewind bar,.
Pile Height
Indicator
Models)
Handle
Pile Height Pedal
(Some Models)
3. Lower wand from upright position by
pressing on the handle release pedal.
CAUTION
DO NOT leave the Power-Mate s
running in one spot in the upright
position for any length of time.
Damage to carpet may occur,
i
i iii1,,
ii
III
4. Select a pike height setting by pressing
the small pedal on the rear of the Power-
Mate _. The pile height setting shows on the
indicator_ See SUGGESTED
PILE HEIGHT
SETTINGS
Attention:
Refer to your carpet manufac-
turers cleaning recommendations.
Some
more delicate carpets
may require that they
be vacuumed
with the Power-Mate s agitator
turned off, to prevent carpet damage.
_OFF
FLOOR
_'_I
ARPET
5. Select a switch
position on the
handle.
OFF
FLOOR - turns on the canister motor only,
CARPET
- turns on both the canister and
the Power-Mate s motors_
NOTE - When this switch is in the FLOOR
position,
the headlight
and dirt sensor
(some models) DO NOT function since no
electricity
flows to the Power-MateSo
Advertisement
