Advertisement
1. Unplug cord from wall outlet. DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent
and water, then wrung dry.
Wipe dry after cleaning.
3. To reduce static electricity and dust build-
up, wipe outer surface of cleaner
and
attachments.
Check motor safety filter occasionally
and
Do not use attachments
if they
are wet. Attachments
used in
dirty areas, such as under a
refrigerator,
should not be used
on other surfaces
until they are
washed. They could leave marks.
change when dirty.
WARNING
Electrical
Shock Hazard
Unplug power cord from electrical
outlet.
Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed
to prevent motor failure
and/or electrical
shock.
11
iiiii
i i iiiii1,1
Remove the bag as outlined in the BAG
CHANGING
section.
MOTOR SAFETY FILTER
ELECTROSTATIC
This white filter must be replaced when
dirty. It should be replaced regularly
depending
on use conditions.
The filter
CANNOT
be washed
as it will lose its
dust trapping
ability.
NOTE: See PARTS AND FEATURES
for
motor safety filter number.
1. Lift the rubber
retainer and pull
out motor safety
filter as shown°
'/_
"_ // z/z / Retainer
retainer,
2. Replace the fil-
ter, rough side
out, facing the dust
bag, by sliding it
back into place
under the ribs in
the bag cavity.
Tuck filter in so that
it fits completely
under the rubber
3. Replace the bag as outlined in the BAG
CHANGING
section,
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials,
such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause it to burst before
it is full. Change bag more often
when vacuuming
these materials.
15
Advertisement
