HP Pavilion dm1 Maintenance And Service Manual page 84

Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Service cover (see
b. Keyboard (see
c. Top cover (see
d. System board (see
Remove the power connector cable:
1. Turn the system board upside down, with the right side toward you.
2. Disconnect the power connector cable (1) from the system board.
3. If necessary, separate the power connector bracket (2) from the power connector.
Reverse this procedure to install the power connector cable and bracket.
76 Chapter 4 Removal and replacement procedures
Battery on page 44), and then remove the following components:
WLAN module on page
Keyboard on page 58)
Top cover on page 68)
System board on page
48)
74)