Installing The Batteries - Garmin GPSMAP 60CSx Owner's Manual

G S >
ETTING TARTED

Installing the Batteries

The GPSmap 60CSx operates on two AA batteries
(not included), which are located in the back of the
unit. You can use Alkaline or NiMH batteries. See
page 67 for information on setting the battery type.
To install the batteries:
1. Remove the battery cover
2. Insert the batteries,
3. Reinstall the battery cover
Battery
Compartment
Remove the batteries from your GPSMAP 60CSx
when you do not expect to use the unit for several
months. Stored data is not lost when batteries are
removed.
2
by turning the D-Ring 1/4
turn counter-clockwise and
pulling the cover loose.
observing the proper
polarity. A polarity diagram
is molded into the battery
compartment.
by aligning the back cover
with the unit and turning the
D-Ring 1/4 turn clockwise.
To install the Lanyard:
1. Place the loop of the Lanyard through the slot
at the at the upper left side on the back of the
unit.
2 Route the strap through the loop and pull tight.
Wrist Strap
Installation
Refer to page 9 for information on accessing the
microSD data card in the battery compartment.
GPSMAP 60CSx Owner's Manual