ECS 915-M5 Manual page 42

36
Super IO Configuration (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Onboard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1/2 Address (3F8/IRQ4/2FB/IRQ3)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a port
address.
Serial Port2 Mode (Normal)
It Serial Port2 Address is not disabled, it allows you to set the Serial Port 2 Mode.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Parallel Port Mode(ECP)
Use this item to select the parallel port mode.
ECP Mode DMA channel (DMA3)
This item assigns a DMA channel to the parallel port. The options are 0,1,and 3.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Press <Esc> to return to the advanced setup page.
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
OnBoard Floppy Controller
Serial Port1 Address
Serial Port 2 Address
Serial Port 2 Mode
Parallel Port Address
Parallel Port Mode
ECP mode DMA channel
Parallel Port IRQ
: Move
Enter : Select
F7:Previous Values
SuperIO Configuration
[Enabled]
[3FB/IRQ4]
[2FB/IRQ3]
[Normal]
[378]
[ECP]
[DMA3]
[IRQ7]
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
F8:Fail-Safe Defaults
Using BIOS
Help Item
Allows BIOS to Enable or
Disable Floppy Controller.
F1: General help