La Crosse Technology D000.104 Instruction Manual

Replacement H2O Sensor on 6 ft. Cable
for La Crosse Alerts™ TX70U-IT
Remote Water Detector
Model: D000.104
When connected to a La Crosse Alerts™ TX70U-IT water
detector with temperature and humidity, this 6 ft. H2O sensor
cable detects wet (H20) and dry (DRY) conditions and sends
you early warning text and e-mails to notify you of a water leak
before it has time to cause extensive damage.*
Prevent property damage to your home, business or vacation
rentals caused by faulty pipes, hoses, sinks, sumps & mold.*
Monitor the kitchen, bath, basement, and laundry or pool
room.*
MONITORING OPTIONS
Note: ** The H20 Sensor detects the presence or absence of
water which is displayed on the LCD: WET (H20) / DRY status
(Channel 2). Attach it to the main sensor case and place the
sensor on the floor or other area you wish to monitor for
WET/DRY conditions.
• Kitchens, baths, laundry & pool rooms
• Utility sinks, sumps & water heaters
• Home, business, rentals and vacation homes
• Basements, garages & attics
• Near aquariums and terrariums
• Greenhouses & farms

REPLACEMENT H2O SENSOR ON 6 FT CABLE

• Works with existing La Crosse Alerts™ TX70U-IT water
detector with temperature and humidity
• Water Detector (Channel 2): Use the 6 Ft. detachable H2O
sensor to measure water.

PACKAGE CONTENTS

1. H20 (water) sensor on 6 Ft. detachable cable (D000.104)
that detects WET (H20) or DRY (DRY) conditions.
2. Instruction manual
ADDITIONAL EQUIPMENT (NOT INCLUDED)
TX70U-IT Wireless water detector with temperature and
humidity monitor

FEATURES

D000.104 Water Sensor on 6 Ft. Detachable Cable:
Detects the presence or absence of water which is displayed
on the LCD: WET (H20) / DRY status (Channel 2)
•
(A) Attach the replacement cable to the (B) main sensor
case and place the sensor on the floor or other area you
wish to monitor for WET/DRY conditions.
•
(A) The official D000.104 H20 Sensor can be plugged into
the sensor at any time without resetting.
(B):
TX70U-IT
SENSOR
LCD
Is Not
Included
LED
Button
(A)
• (A) Connects to an existing La Crosse Alerts™ TX70U-IT
water detector with temperature and humidity sensor and
your existing Gateway and router to upload measurements
to lacrossealerts.com for remote monitoring and alerts.*
(TX70U-IT required, not included).
1. Insert the H2O sensor cord into your existing TX70U-IT
water detector (not included).
2. Place H2O sensor on the floor (circuit board down).
• The TX70U-IT sends the temperature/humidity
measurements and the wet (H20) or dry (DRY)
measurements from the H2O sensor to your existing La
Crosse Alerts™ Gateway (not included).
• Once set up, you can login to your La Crosse Alerts™
account and view your temperature, humidity and H2O
sensor with an Internet-connected mobile device, tablet or
computer with a web browser*.
This socket is ONLY
for the water sensor.
DO NOT insert
power plug into it.
**H2O sensor with
6-foot wire to plug into sensor
SETUP
1