Agri-Fab 45-03642 Owner's Manual page 7

23. Place the adjustable stop (S) into the "ON" end of the slot
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt (F), a nylon washer
(J), a 5/16" flat washer (K) and the nylon wing nut (R).
See figure 12.
(R) NYLON
WING NUT
(K) 5/16" FLAT
WASHER
(J) NYLON
WASHER
(S) ADJUSTABLE
STOP
(F) 1/4" x 3/4"
CARRIAGE BOLT
FIGURE 12
24. Slide the adjustable stop to the end of the slot. Move the
flow control arm against the stop. Assemble the spring
(X) to the flow control mounting bracket and then to the
flow control rod. See figure 13.
(X) SPRING
FLOW
CONTROL
ROD
FIGURE 13
25. Position the flow control mounting bracket (figure 14).
a. Push flow control arm to "OFF" position.
b. Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
c. Snug the 5/16" lock nuts just enough to hold flow
control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of flow control mounting bracket until
closure plate will open about half way at "5" and
will still close when arm is locked in "OFF" position.
Tighten the 5/16" lock nuts.
FLOW
CONTROL
ARM
ADJUSTABLE
STOP (S)
(SETTING "5")
FIGURE 14
26. Place the screen down into the hopper, sliding the edge
of the screen under one of the clips. Slightly bow the
screen to slide the opposite side of the screen under
the other clip. See figure 15.
FIGURE 15
7
CLIPS