Toyota 4RUNNER Warranty & Maintenance Manual page 71

Check installation of driver's floor mat
Inspect and adjust all fluid levels
Lubricate propeller shaft
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter
Replace spark plugs
Rotate tires
Inspect the following:
__ Automatic transmission fluid
__ Ball joints and dust covers
__ Brake lines and hoses
__ Brake linings/drums and brake pads/discs
__ Drive belts
__ Drive shaft boots (4WD)
6
__ Engine coolant
__ Exhaust pipes and mountings
__ Front differential oil (4WD)
Additional Maintenance Items for Special Operating Conditions
Driving on dirt roads or dusty roads:
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading:
Replace automatic transmission fluid
Replace front differential oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
D S V
EALER ERVICE ERIFICATION
D :
ATE
M :
ILEAGE
1
Reset the oil replacement reminder light ("MAINT REQD") or the message "OIL MAINTENANCE REQUIRED" on the
multi-information display after engine oil replacement.
2
Perform these service items only if you drive primarily under the conditions indicated.
3
Includes operating on roads which road salt has been applied.
4
Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty.
5
Inspect thickness measurement and disc runout.
6
Refer to "Engine Coolant" in the "Explanation of Maintenance Items" section in the back of this guide for more
information.
SCHEDULE B - 6 CYLINDER SYNTHETIC ENGINE OIL
120,000 miles or 144 months
1
4
5
:
Schedule B — 6 Cylinder
__ Fuel lines and connections, fuel tank band
and fuel tank vapor vent system hoses
__ Fuel tank cap gasket
__ Radiator and condenser
__ Rear differential oil
__ Steering gear box
__ Steering linkage and boots
__ Transfer case oil (4WD)
2
69
Maintenance Log