Download Print this page

Advertisement

Quick Links

4

SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, and injury, please follow
these basic safety precautions before you use this equipment.
1.
Carefully read the instructions in this manual.
2.
Follow all warnings and instructions marked on the unit.
3.
When cleaning, unplug the telephone jack from the wall outlet. Use
a damp cloth.
DO NOT
use liquid or aerosol cleaners.
4.
Do not use this equipment near water, eg: near a kitchen sink,
bathtub, washbowl, laundry rub, swimming pool or in a wet
basement.
5.
Install in a protected location. Ensure all lines and cords are away
from foot traffic.
DO NOT
cause damage or abrasion.
6.
Avoid spilling any liquid on the unit. This may cause internal
shorting, fire or shock and is not covered under your warranty.
7.
Do not overload wall outlets and extension cords as this can result
in the risk of fire or electrical shock.
8.
Never push objects of any kind into this telephone as they can
touch dangerous voltage points or short out parts that could result
in a risk of fire or electrical shock.
9.
Take the phone to a qualified technician when it requires repair
work or service. To reduce the risk of electrical shock, do not
disassemble the telephone. Opening or removing covers can
expose you to dangerous voltages or other risks. Incorrect re-
assembly can cause electrical shock during subsequent use.
10.
Avoid using the telephone during an electrical storm. There can be
a slight risk of electrical shock from lightning.
11.
DO NOT
use the telephone to report a gas leak, if in the vicinity of
the leak.
12.
Unplug this telephone from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
l
If liquid is spilled into the unit.
l
If the unit is exposed to rain or water.
l
If the unit does not operate normally by following the
operating Instructions.
l
If the unit is dropped or the casing is damaged.
l
If the unit exhibits a distinct change in performance.
place objects on the line cord that may
7
O
WNER'S
I
M
NSTRUCTION
ANUAL
MODEL 1201

Advertisement

loading

Summary of Contents for Cortelco 1201

  • Page 1: Safety Instructions

    Unplug this telephone from the wall outlet and refer servicing to MODEL 1201 qualified service personnel under the following conditions: If liquid is spilled into the unit.
  • Page 2: Wall Installation

    WALL INSTALLATION LOCATION OF CONTROLS Slide the handset tab out and rotate it 180 degrees so that the hook points up. This will hold the handset in the cradle when the phone is mounted on the wall. Remove the desk stand from the phone base (see diagram 2). Memory LCD display Message lamp...
  • Page 3 10. Hold button To place a call on hold, press HOLD and hang up the handset. To retrieve the call lift the handset or go off hook on any other phone connected to the line. Dialing mode Pause button switch Pressing this button will insert a 3 second pause in the dialing sequence.
  • Page 4 Volume setting OPERATIONS Press the VOL.+ VOL.- buttons to adjust the receive volume during a conversation. There are 4 levels. 1. Dial mode switch 8. One-touch memory This switch is located on the bottom of the telephone. For Tone Dialing, set the switch to the T position.