GE JKP20 Owner's Manual page 24

Before YouCall For Service...
Troubleshoo_ng - tips
Possible Causes
You have a function
error code.
If the function
code repeats.
A fuse in your home may
be blown or the circuit
breaker tripped. -
The clock is in the
black-out mode.
What ToDo
• Press the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
Power failure. • Reset the clock.
Oven control pads were
not pressed properly.
• The BAKE and BROILHI/LO pads must be pressed
at the same dine and held for 3 seconds.
Power outage or surge.
This is normal in a
new oven and will
disappear in time.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
A cooling fan may
automatically turn
on and off.
• Reset the clock. If the oven was in use, you must reset
it by pressing the CI.E4R/OFF pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum
of 3 hours. See the Using the self-cleaning
oven section.
]eThis is temporary.
• This is normal. The cooling fan will turn offand on
to cool internal parts. It may run after the oven is
turned OFF.
24