Connecting Electrical Wiring - Daikin FDXS09DVJU Installation Manual

Caution
• When doing the wiring, make sure the wiring is neat and does not cause the control box lid to stick up, then close the cover
firmly. When attaching the control box lid, make sure you do not pinch any wires.
• Outside the unit, separate the low voltage wiring (remote controller wiring) and high voltage wiring (earth wire and power supply wiring) at
least 5in so that they do not pass through the same place together. Proximity may cause electrical interference, malfunctions, and breakage.
[ PRECAUTION ]
• See also the "Electrical Wiring Diagram Label" when wiring the unit for power supply.

[ Connecting electrical wiring ]

• Power supply wiring and Earth wire
Remove the control box lid.
Next, pull the wires into the unit through the conduit and thread them
through the insulation tube (accessory), then connect to the power wiring
terminal block (4P).
Secure the wires covered by the insulation tube with the clamp
(accessory).
Be sure to put the part of the sheathed vinyl into the control box.
Warning
Do not use tapped wires, stand wires, extensioncords, or starbust connections, as they may cause overheating, electrical shock, or fire.
1
Indoor
2
unit
3
Clamp
(for fixing in place)
Terminal block (4P)
(accessory)
Insulation tube
(accessory)
Indoor PCboard
(ASSY)
Power supply wiring
Ground wire
To outdoor unit
Power supply wiring
Ground wire
Conduit
Power supply wiring
Ground wire
11