Daikin FAQ18PVJU Operation Manual page 9

NOTE
• If you try cooling or programmed drying, while
the fl aps are facing downward, air fl ow direction
may change unexpectedly. There is nothing
wrong with the equipment. This serves to prevent
dew formed on parts in the air discharge outlet
from dripping.
• Operation mode includes automatic operation.
Recommended fl ap positions
Cooling
Heating
We recommend using the fan in the position listed
above when fi xing the fan direction.
B. LEFT AND RIGHT DIRECTION
Hold the tabs on edge louvers (horizontal fan direc-
tion adjustment fl aps) down slightly and adjust left
and right to match the room conditions or your
preference.
Stop the horizontal fl aps at a position where you
can hold the tabs and adjust it left and right.
NOTE
• Only make adjustments after you have stopped
the air fl ow direction swing in a position where
adjustments are possible. Your hand may get
caught if you attempt to make adjustments while
the unit is swinging.
7
COOLING, HEATING, AUTOMATIC, FAN,
AND PROGRAM DRY OPERATION
Operate in the following order.
OPERATION MODE
1
SELECTOR
Press OPERATION MODE SELECTOR
button several times and select the
OPERATION MODE of your choice as
follows.
COOLING OPERATION ..............................."
HEATING OPERATION ................................."
AUTOMATIC OPERATION ............................"
• In this operation mode, COOL/HEAT change-
over is automatically conducted.
FAN OPERATION ........................................."
DRY OPERATION ........................................."
• The function of this program is to decrease the
humidity in your room with the minimum tem-
perature decrease.
• Micro computer automatically determines
TEMPERATURE and FAN SPEED.
• This system does not go into operation if the
room temperature is below 60°F.
Refer to fi gure 3 on page [1]
2
ON/OFF
Press ON/OFF button.
OPERATION lamp lights up or goes off and the
system starts or stops OPERATION.
[EXPLANATION OF HEATING OPERATION]
DEFROST OPERATION
• As the frost on the coil of an outdoor unit in-
crease, heating effect decreases and the system
goes into DEFROST OPERATION.
• The indoor unit fan stops and the remote control-
ler display shows "
• After 6 to 8 minutes (maximum 10 minutes) of
DEFROST OPERATION, the system returns to
HEATING OPERATION.
"
"
"
"
"
".
English