Operation Procedure - Daikin FAQ18PVJU Operation Manual

6.

OPERATION PROCEDURE

Read the operation manual that came with
the remote controller.
• Operating procedure varies with heat pump type
and cooling only type. Contact your Daikin dealer
to confi rm your system type.
• To protect the unit, turn on the main power
switch 6 hours before operation.
• If the main power supply is turned off during
operation, operation will restart automatically
after the power turns back on again.
2
1
10
9
8
1. Air fi lter (Inside the front panel)
2. Air inlet (front and top of main unit)
3. Name plate
(Indoor unit model name)
4. Refrigerant pipe, Transmission wire
5. Drain pipe
6. Remote controller
7. Ground wire
Provided to ground the indoor unit to prevent
an electric shock and ensure safety
8. Horizontal fl aps
(adjustment fl aps for air outlet direction up
and down)
9. Louver
(adjustment fl aps for air outlet direction to
the right and left)
10. Air outlet
English
•
3
4
A. UP AND DOWN DIRECTION
Press the AIR FLOW DIRECTION ADJUST but-
5
ton to select the air direction as following.
6
7
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air fl ow direction so it may be different
from the display.
Operation
mode
Operation
conditions
AIR FLOW DIRECTION ADJUST
There are 2 ways of adjusting the air discharge
angle.
A. Up and down direction
B. Left and right direction
The AIR FLOW FLAP display
swings as shown below and the
air fl ow direction continuously
varies. (Automatic swing setting)
swing
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air fl ow
direction is fi xed (Fixed air fl ow
direction setting).
Cooling
• When operat-
ing continu-
ously at down-
ward air fl ow
direction
Heating
• When room tem-
perature is higher
than the set tem-
perature
• At defrost opera-
tion
(The fl aps blow
horizontally to
avoid blowing cold
air directly on the
occupants of the
room.)
6