G Off Timer Operation; G On Timer Operation - Daikin FT25JV1A Operation Manual

Timer Operation
Timer functions are useful for automatically
switching the air conditioner on or off at night or in
the morning. You can also use OFF TIMER and
ON TIMER in combination.
OFF TIMER operation
G Check that the clock is correct.
If not, set the clock to the present time. (See page 8.)
1
Press while the air conditioner
OFF
is operating.
AM
2
Press until the time setting
TIMER
reaches the point you like.
G Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
3
Press OFF once again.
AM
I I I I I To cancel the timer:
Press .
Then the TIMER lamp goes off.
CANCEL
Notes on OFF TIMER
G NIGHT SET MODE
When the OFF TIMER is set, the air
conditioner automatically adjusts the
temperature setting (0.5°C up in COOL) to
prevent excessive cooling for your pleasant
sleep.
is displayed.
AM
blinks.
* Previous time setting
appears on display.
ON
OFF
Then the TIMER lamp
lights up.
ON TIMER operation
G Check that the clock is correct. If not, set the
clock to the present time (See page 8).
1
ON
Press while the air conditioner is
not operating.
AM
2
Press until the time setting
TIMER
reaches the point you like.
G Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3
Press once again.
ON
AM
Then the TIMER lamp lights up.
I I I I I To cancel the timer:
Press .
CANCEL
Then the TIMER lamp goes off.
Combining ON TIMER and OFF TIMER
G A sample setting for combining the two timers is shown below.
(Example)
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
AM
Notes on ON,OFF TIMER
G When TIMER is set, the present time is not displayed.
G Once you set ON,OFF TIMER, the time setting is
kept in the memory. (The memory is canceled when
remote controller batteries are replaced.)
G When operating the unit via the ON/OFF Timer, the
actual length of operation may vary from the time
entered by the user. (Maximum approx. 10 minutes.)
ATTENTION
I In the following cases, set the timer again.
G After a breaker has turned OFF.
G After a power failure.
G After replacing batteries in the remote controller.
is displayed.
AM
blinks.
* Previous time setting
appears on display.
ON
OFF
    
Combined
    
AM
11