Daikin BRC4C61 Operation Manual page 15

For example.
ON OFF
TEMP
TIME
C
UP
DOWN
FAN
RESERVE CANCEL
hr.
TIMER
hr.
• After the timer is programmed, the display
shows the remaining time.
• Press the TIMER OFF button to cancel
programming. The display vanishes. (
HOW TO SET MASTER REMOTE
CONTROLLER (For VRV series)
• When the system is installed as shown
below, it is necessary to designate the
master remote controller.
〈〈For Heat pump system〉〉
When one outdoor unit is connected with
several indoor units.
Outdoor unit
One of these remote controllers
needs to be designated as the
master remote controller.
English
When the timer is
programmed to stop
the system after
3 hours and start the
system after
4 hours, the system
will stop after
3 hours and then
1 hour later the sys-
tem will start.
4
Indoor unit
〈〈For Heat recovery system〉〉
When one BS unit is connected with several
indoor units.
Outdoor unit
BS unit
)
One of these remote controllers
needs to be designated as the
master remote controller.
• Only the master remote controller can
select HEATING, COOLING or AUTO-
MATIC (only Heat recovery system)
OPERATION.
When the indoor unit with master remote
controller is set to "COOL", you can switch
over operation mode between "FAN", "DRY"
and "COOL".
When the indoor unit with master remote
controller is set to "HEAT", you can switch
over operation mode between "FAN" and
"HEAT".
When the indoor unit with master remote
controller is set to "FAN", you cannot switch
operation mode.
When attempting settings than that con-
sented above, a "peep" is emitted as a warn-
ing.
Only with Heat recovery system, you can set
the indoor unit to AUTOMATIC. Attempting to
do so, a "peep" will be emitted as a warning.
Indoor unit
10