Training With Cadence; Gsc 10 Battery; Edge 605/705 Owner's Manual - Garmin Edge 705 Owner's Manual

U a
SinG cceSSorieS
red LED blinks each time the
crank arm passes the sensor,
and the green LED blinks each
time the wheel magnet passes
the sensor arm.
note: The LED blinks
for the first 60 passes after
a reset. Press
if you require additional
passes.
6. When everything is aligned
and working correctly, tighten
the cable ties, sensor arm, and
spoke magnet.
Training with �adence
Cadence is your rate of pedaling or
"spinning" measured by the number
of revolutions of the crank arm per
minute (rpm).
0
reset again
There are two sensors on the GSC 10:
one for cadence and one for speed.
Cadence data from the GSC 10 is
always recorded. The speed data from
the GSC 10 is only recorded and
used for distance calculation when
the GPS signal is weak or the GPS is
turned off.
For information about cadence alerts,
see page 18.
For information about speed zones,
see page 54.
GS� 10 Battery
For GSC 10 battery information, see
page 59.

Edge 605/705 Owner's Manual