Changing Bluetooth Technology Settings; Changing The Proximity Points Settings - Garmin BMW Motorrad Navigator IV Owner's Manual

Customizing the zūmo
add (or Subscriptions > add)—add a
new subscription to a traffic service. Go to
www.garmin.com/fmtraffic to purchase a
subscription.
The traffic subscription code cannot be
reused. You must obtain a new code each
time you renew your service. If you own
multiple FM traffic receivers, you must
obtain a new code for each receiver.
Changing Bluetooth
Technology Settings
Tools Settings > Bluetooth.
Touch >
Phone or audio—select add
with a device that has Bluetooth wireless
technology. To listen to high-quality
audio wirelessly, connect to a Bluetooth
headset that supports the A2DP profile.
See pages 17–19. Select Change
and connect with a different device. The
Navigator IV PIN code (or passkey) is 1234.

Drop—select the device you want to
disconnect, and touch Yes.
remove—select the device you want to
delete from the Navigator IV memory,
and touch Yes.
Bluetooth—enable and disable the
Bluetooth component. The
icon appears on the Menu page if the
Bluetooth component is enabled. To prevent
a device from automatically connecting,
select Disabled.
Friendly name—enter a friendly name that
identifies your Navigator IV on devices with
> oK to pair Bluetooth technology. Touch Done.
restore—restore the original Bluetooth
settings. This does not clear the pairing
information.
to pair
Changing the Proximity
Points Settings
You must have proximity points (such as
custom POIs, a safety camera database,
or a TourGuide
proximity point settings. See
Bluetooth Touch Tools
Proximity alerts—touch
alerts on or off when you approach custom
POIs or safety cameras.
Tourguide—set how you want the audio for
TourGuide to be activated. Select
to hear the complete tour as programmed;
Prompted
the map when tour information is available
during your route; or off.
restore—restore the original proximity
points settings.
BMW Motorrad Navigator IV Owner's Manual
file) loaded to adjust the
®
pages 35–36.
> Settings > Proximity Points.
Change
to turn the
auto Play
to show the speaker icon on