Refrigerator Use; Normal Sounds; Refrigerator Features; Refrigerator Shelves - Jenn-Air W10549542A Use & Care Manual

REFRIGERATOR USE REFRIGERATOR FEATURES
Your new refrigerator may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
• Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
• Rattling noises may come from the flow of refrigerant or items
stored inside the refrigerator.
• As each cycle ends, you may hear a gurgling sound due to the
refrigerant flowing in your refrigerator.
• You may hear water running into the drain pan when the
refrigerator is defrosting.
• You may hear clicking sounds when the refrigerator starts or
stops running.
The control is located behind the base grille. Lift up on the door in
the center of the grille to access the control.
For your convenience, your refrigerator temperature control is
preset at the factory. When you first install your refrigerator, make
sure that the control is still preset to the mid-setting as shown.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
To Remove or Adjust Upper Shelves:
1. Remove the shelf by lifting it up and out of the shelf brackets.
2. Remove the two shelf brackets and reposition them in the
desired location.
3. Replace the shelf by inserting it into the shelf brackets.
NOTE: Be sure the shelf is level.
\
To Remove and Replace Lower Shelf:
1. The very bottom glass shelf slides straight out.
2. Replace the shelf by aligning the edges with the guides and
pushing it in toward the back of the refrigerator.
Adjusting Controls
The mid-setting should be correct for normal usage. The control is
set correctly when beverages are as cold as you like.
If you need to adjust the temperature, wait at least 24 hours
between adjustments and then recheck the temperature.
To make the refrigerator colder, adjust the control to the next
higher setting. To make the refrigerator less cold, adjust the
control to the next lower setting.
\