Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DV 403 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DV Mark DV 403

  • Page 2: Important Safety Instructions

    MORE INFORMATION For warranty and service information, please contact your local DV Mark distributor (contact information available at www.dvmark.it). For more technical information, please visit us at www.dvmark.it and fill out the form on the Contact Us page. We hope you enjoy your amplifier and use it to make great music! “The Lightning Flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”...
  • Page 3 The second is flexibility. One example of this is DV Mark’s patent pending Continuous Power Control feature (included on our 40W heads and combos), which allows you to adjust the power incrementally, setting the power at anywhere between 1 and 40W. This means you can get the tone you want at the volume you need;...
  • Page 4: Front Panel

    FRONT PANEL 1) INPUT Connect your guitar to this input using a standard ¼” shielded instrument cable. 2) 0/-6dB SWITCH This switch pads the input (1) from 0 dB to -6 dB to compensate for higher-output sources, such as guitars with high- output pickups or active electronics.
  • Page 5 12) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where they have been sold, and are factory preset to that country’s voltage.
  • Page 6: Rear Panel

    14) PRE OUT/AMP IN The DV 403 CPC features an effects loop for use with outboard effect processors or pedals. Connect the PRE OUT jack to the input of your processor or pedal chain, and connect your effects output to the AMP IN jack.
  • Page 7 -6 dB to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where they have been sold, and are factory preset to that country’s voltage. So make sure you’re sending the correct voltage to your amp before you connect it to AC power.
  • Page 8: Technical Specs

    Service Midi through (Voltage is factory preset according to region of sale). mains DV Mark amps/combos are manufactured to be sold and used in the country Supply fuse of purchase, and they are factory preset to at country’s voltage. On/Off...
  • Page 9: Limited Warranty

    LIMITED WARRANTY...
  • Page 10: Warranty Card

    WARRANTY CARD...
  • Page 12 Product specifications are subject to change without notice www.markbass.it www.markaudio.it www.momark.it Italy - 66020 San Giovanni Teatino CH - Via Po, 52 Tel: +39 0854407764 / 0854465705 - Fax: +39 0854407764 / 0854407399 - www.dvmark.it - info@dvmark.it...

Table of Contents