Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Combo head 40 and is the answer not in the manual?

Questions and answers

Summary of Contents for DV Mark Combo head 40

  • Page 2: Safety Instructions

    MORE INFORMATION For warranty and service information, please contact your local DV Mark distributor (contact information available at www.dvmark.it). For more technical information, please visit us at www.dvmark.it and fill out the form on the Contact Us page. We hope you enjoy your amplifier and use it to make great music! “The Lightning Flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”...
  • Page 3 You need to be able to always trust your amp… and we understand that! The second is flexibility. One example of this is DV Mark’s patent pending Continuous Power Control feature (included on our 40W heads and combos), which allows you to adjust the power incrementally, setting the power at anywhere between 1 and 40W. This means you can get the tone you want at the volume you need;...
  • Page 4: Front Panel

    FRONT PANEL 1) INPUT CH1 (Hi Z 1MΩ) Connect your guitar to this input using a standard ¼” shielded instrument cable. This input is suitable for instruments that have normal-output pickups and passive electronics. 2) INPUT CH2 (Low Z -6dB) This input is padded by 6 dB to compensate for higher output sources, and is suitable for use with guitars that have high-output pickups or active electronics.
  • Page 5 8) MASTER (CH2) This control is the master feed from the end of the preamp channel to the tube power stage. It allows you to obtain a wide range of sounds/ colours in relation to the gain setting—for example, very low gain sounds at high volumes or high gain sounds at low volumes. 9) BASS This knob controls the amount of low frequencies in your sound.
  • Page 6 This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where they have been sold, and are factory preset to that country’s voltage.
  • Page 7 FRONT PANEL...
  • Page 8: Rear Panel

    Make sure the unit is grounded; all three terminals of the AC power cord must be connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where they have been sold, and are factory preset...
  • Page 9 REAR PANEL...
  • Page 10 (Voltage is factory preset according to region of sale) 100V/120V; 230V; 240V 50/60Hz DV Mark amps/combos are manufactured to be sold and used in the country of purchase, and they are factory preset to that country’s voltage. Due to homologation issues, the voltage may not be changed.
  • Page 11: Technical Specs

    TECHNICAL SPECS DV 40 112 COMBO DV 40 212 COMBO Speaker size: 1x12” B&C Neodymium DV Mark Custom Speaker size: 2x12” B&C Neodymium DV Mark Custom Speaker power handling: 150W (AES standard) Speaker power handling: 300W (AES standard) impedance 8 ohms...
  • Page 12: Block Diagram

    BLOCK DIAGRAM ½ ECC83 CH1/CH2 Bright CH1/CH2 CH1/CH2 Master 2 ½ ECC83 ½ ECC83 ½ ECC83 Passive tone LowZ control Solo Gain Master 1 High Power amp Reverb EL34 Pre Out 16 ohm ECC83 Output transformer 8 ohm 4 ohm Amp In EL34 Presence...
  • Page 13: Limited Warranty

    LIMITED WARRANTY...
  • Page 14: Warranty Card

    WARRANTY CARD...
  • Page 15 JULY 2010 DV MARK PRODUCT LINE Heads Bad Boy 120 120W, 3-channel, all-tube rock head Little 40 40W, 1-channel all-tube head with CPC* and 6L6 or EL34 power tubes Cabinets Galileo 15 Pedals 15W, 1-channel all-tube head C 112 Small Guitar Tube Marker 1x12”, super compact and lightweight;...
  • Page 16 Product specifications are subject to change without notice www.markbass.it www.markaudio.it www.momark.it Italy - 66020 San Giovanni Teatino CH - Via Po, 52 Tel: +39 0854407764 / 0854465705 - Fax: +39 0854407764 / 0854407399 - www.dvmark.it - info@dvmark.it...

Table of Contents