Transferring Data To A Microsd Card - Garmin GPSMAP 60Cx Owner's Manual

Transferring Data to a MicroSD Card

The GPSMAP 60Cx is equipped with a pre-installed
MicroSD card.
To install or remove the MicroSD card:
1. Remove the Battery Compartment Cover
from the back of the unit and remove the two
batteries.
2. Locate the card tray at the center of the
battery tray and check to be certain the card is
installed in the tray.
3. If you desire to remove the card, slide the tray
cover up, then lift it toward you to remove the
card from the tray.
4. To re-insert the card, lay the card in the tray,
close the tray, and replace the batteries and
cover when finished.
To transfer map data to the MicroSD card:
1. Lift the weather cover from the USB port on
the upper back of the unit. It recommended
that you use the USB port rather than the
Serial Connection port for faster data transfer.
GPSMAP 60Cx Owner's Manual
2. Connect the USB cable provided with the unit
to the USB port on your PC and to the mini-
USB port on the back of the unit.
3. Follow instructions for selecting and
downloading maps provided with the
MapSource map data disk.
G S >
ETTING TARTED
9