Additional Warnings; Safety Warnings Specific For Sanding Operations - Bosch AG40-85 Operating/Safety Instructions Manual

Hide thumbs Also See for AG40-85:

Operating/safety instructions manual (76 pages)

Table of Contents

Available languages

Additional Safety Warnings Specific for

Abrasive Cutting-Off Operations:

Do not "jam" the cut-off wheel or apply

excessive pressure. Do not attempt to make

an excessive depth of cut.

Do not position your body in line with and

behind the rotating wheel.

When wheel is binding or when interrupting

a cut for any reason, switch off the power

tool and hold the power tool motionless

until the wheel comes to a complete stop.

Never attempt to remove the cut-off wheel

from the cut while the wheel is in motion

otherwise kickback may occur.

Do not restart the cutting operation in the

workpiece. Let the wheel reach full speed

and carefully reenter the cut.

Support panels or any oversized workpiece

to minimize the risk of wheel pinching and

kickback.

Use extra caution when making a "pocket

cut" into existing walls or other blind areas.

Always use type 1 cutting guard for cutting

operations.

Do not attempt to cut large stock or sheets

of metal as this machine is not designed to

be a dedicated cut-off machine.

Safety Warnings Specific for

Sanding Operations:

Do not use excessively oversized sanding

disc paper. Follow manufacturer's

recommendations, when selecting sanding

paper.

A guard may not be used for all sanding

operations. Do not discard guard when not

in use.

Safety Warnings Specific for

Wire Brushing Operations:

Be aware that wire bristles are thrown by

the brush even during ordinary operation.

Do not overstress the wires by applying

excessive load to the brush.

If the use of a guard is recommended for

wire brushing, do not allow any interference

of the wire wheel or brush with the guard.

A guard may not be used for all wire

brushing operations.

Do not use a knotted wire brush with this

tool.