Usb Interface Troubleshooting - Garmin 300 Owner's Manual

a
PPendix

USB Interface Troubleshooting

Problem/Question
How do I know my nüvi
is in USB Mass Storage
Mode?
My computer never
senses that the nüvi is
connected.
I cannot find any drives
named "nuvi" in my list
of drives.
I keep getting a message
saying "Unsafe Removal
of Device" when I unplug
the USB cable.
Garmin © 2005–2006
When your nüvi is in USB Mass Storage Mode, a picture of a nüvi
connected to a computer is shown. Also, you should see a new
removable disk drive listed in My Computer (Windows) or a new
volume (drive) on your desktop (Mac).
1. Unplug the USB cable from your computer.
2. Turn the nüvi off and then back on again.
3. Plug the USB cable into your computer. The nüvi automatically
turns on and goes into USB Mass Storage Mode.
Try the solution listed above.
If you have several network drives mapped on your computer,
Windows may have trouble assigning drive letters to your nüvi drives.
Follow the steps on the
Verify that your computer has the latest updates installed. If not,
update your computer, and then connect the nüvi.
Windows users, double-click the
system tray. Select "USB Mass Storage Device" and click Stop. Select
the nüvi drives and click OK. You can unplug your nüvi from your
computer now.
Mac users, drag the volume icon to the Trash. The Trash icon
changes to an Eject
Solution/Answer
following page to assign your drive letters.
Unplug or Eject
icon.
6
icon in your
nüvi Owner's Manual