Online/Offline; Configuration; Editing - dbx Zone Pro 640 User Manual

™
ZonePro
Section 2
Software Operation

2. 4 - Online/Offline

The ZonePro Designer GUI provides a mechanism for creating scenes and device files while
not physically connected to a ZonePro unit. To work off-line, open the GUI, select DEVICE
then select ADD. At this point you will be prompted to choose a 640 or 641. Once the unit
has been inserted into GUI you can proceed to configure, edit, create scenes, and save
ZonePro device files.

2. 5 - Configuration

Configuration of the ZonePro is done from the Configuration Wizard and allows setup of the
inputs and outputs along with selection of their processing modules, zone controller setup, sig-
nal routing, and front panel setup. For a detailed operation description see "The Wizard" sec-
tion 3.1.

2. 6 - Editing

To edit a processing module, double click on that module. Adjust the module to taste; make
sure that the module is engaged. This is usually indicated by the module ON button in the
upper left corner of the parameter section. Although process editing is done in real-time, the
changes can either be discarded or accepted by selecting the OK or CANCEL button. The
following screen shot shows the example of the Output Delay module. Parameters can be
copied and pasted between like modules in the ZonePro GUI. From the program screen either
right click on the module and select Copy, or select Edit and Copy from the Menu Bar to Copy
parameters. To past either right click and select Paste, or click on Edit Paste from the Menu
Bar.
®
7
ZonePro ™ User Manual