Troubleshooting - Philips AC4064 Manual

4 To remove the pre-filter, slide it out of the appliance (Fig. 19).
inserting the filters
Tip: Place the appliance against a wall for more stability when you remove or insert filters.
Note: Make sure you insert the filters in the correct position (with the arrow facing upwards).
Note: The appliance is equipped with a safety device. If you have not placed the ESP particle filter, the
zeolite gas filter and the front panel properly, you cannot switch on the appliance.
1 Slide the zeolite gas filter into the appliance. (Fig. 5)
2 Slide the ESP particle filter into the appliance (Fig. 6).
3 Slide the pre-filter into the appliance. (Fig. 20)
4 To reattach the front panel, insert the bottom edge first (1) and then press the top part
home (2) (Fig. 7).
guarantee and service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Consumer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local
Philips dealer.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 21).

Troubleshooting

This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem
The selected function/
time mode doesn't
work.
The appliance doesn't
work.
Solution
The appliance may be in standby mode or may be switched off.
There may be a connection problem. Check if the plug is inserted in
the wall socket properly.
The appliance may not be switched on. AC4064/AC4054: press the
function selection button. AC4062/AC4052: press the on/off button.
The ESP particle filter or the front panel may not be placed properly.
Reinsert the filters and reattach the front panel.
The zeolite gas filter is not placed yet. Insert the filter and reattach the
front panel.
If you have performed the above checks and the appliance still does not
work, it may be malfunctioning. Unplug the appliance and take it to your
Philips dealer or an authorised Philips service centre.
English
11