Philips AC4002 User Manual page 17

Hide thumbs Also See for AC4002:

Table of Contents

English

Filter

Filter 2: multi-care filter

Filter 3: activated carbon filter

Filter 4: HEPA filter

Put filter 1 (pre-filter) back into the appliance.

Note: Make sure that the side with the two projections points towards you.

Note: Make sure that all hooks are properly attached to the appliance.

To reattach the front panel, insert the two hooks into the top of

the appliance first (1). Then push the panel against the body of the

appliance (2).

Put the plug in the wall socket and switch on the appliance again.

Press and hold the reset button below the filter replacement light of

the filter you have replaced to reset the appliance.

Press and hold the reset button for filter 2 for 2 seconds if you have

replaced filter 2 (multi-care filter).

Press and hold the reset button for filter 3/4 for 2 seconds if you have

replaced filter 3 (activated carbon filter) and 4 (HEPA filter).

You hear a beep and the appliance starts operating in the auto mode

again.

Accessories

New filters are available under the following type numbers:

Type number

AC4121

AC4123

AC4124

Table of Contents

Ac4004