Whirlpool 24-Inch - Built-In Dishwasher (Color: Silver) Energy Installation Instructions Manual page 9

ConneCt drain hose to waste tee or waste disposer
using one Ofth e fo!!owing options:
* Option A; WaSte disp0ser _ no air gap
, Opti0n B_ No Waste disposer - no ai r gap
, Option C, Waste disposer - with air gap
i Option D, No waste disPoSer- With air gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least 20"
(50.8 cm) above the floor where the dishwasher will be installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
Option A, Waste disposer - no air gap
1. Using a hammer and screwdriver, knock
plug into disposer.
2. Use needle-nose pliers to remove plug.
3. Attach drain hose to disposer inlet with
large silver drain hose clamp (provided).
Use pliers to squeeze clamp open and
move into position.
Option B, No waste disposer - no air gap
1. Connect black end of of drain hose to waste
tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach black end of drain hose to waste tee
with a large silver drain hose clamp (provided).
Use pliers to squeeze clamp open and move
into position. If the drain hose was cut, use a
1l&,, to 2" (3.8 to 5 cm) screw-type clamp (not
provided).
Option C, Waste disposer - with air gap
Drain trap
1. Using a hammer and screwdriver, knock
plug into disposer.
2. Use needle-nose pliers to remove plug.
3. Connect black end of drain hose to air gap
and cut if needed.
NOTE: Do not cut ribbed section.
4.
5,
Attach drain hose to air gap with large
silver drain hose clamp (provided). Use
pliers to squeeze clamp open and move
into position. If the drain hose was cut, use
a 11/2 '' to 2" (3.8 to 5 cm) screw-type clamp
(not provided).
Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
Option D, No waste disposer - with air gap
1. Connect black end of drain hose to air gap
and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach drain hose to air gap with large silver
drain hose clamp (provided). Use pliers to
squeeze clamp open and move into position.
If the drain hose was cut, use a 1W' to 2"
(3.8 to 5 cm) screw-type clamp (not
provided).
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.