Download Print this page

Whirlpool 24-Inch - Built-In Dishwasher (Color: Silver) Energy Installation Instructions Manual page 15

Undercounter dishwasher plastic giant tub models
Hide thumbs Also See for 24-Inch - Built-In Dishwasher (Color: Silver) Energy:

Advertisement

Available languages

Available languages

IMPORTANT:
Ifwheels were removed,
cover thefloor w hen
moving thedishwasher
toavoid d amage tothe floor. Slowly
move d ishwasher
completely
intocabinet opening. Donotkink or
pinch w ater line, d rain hose, power supply cord ordirect wire
between dishwasher
and cabinet. Remove cardboard
from under
dishwasher.
NOTE: Itisallright i fdishwasher
fitstightly into cabinet opening.
Donotremove insulation blanket - the blanket reduces the
sound l evel.
NOTE: Ifusing p ower cord, make s ure toroute end through hole
incutout before sliding i ntocabinet opening.
Align front o fdishwasher
door p anel withfront o fcabinet doors.
You may need t oadjust alignment tobeeven w ithyour
cabinets.
Check that l eveling legs a re firmly a gainst the floor.
Close and latch t hedoor, and place l evel against the
front p anel. Check that d ishwasher
iscentered from front t oback
inthe opening. Ifneeded, adjust leveling leg until dishwasher
is
plumb. Repeat forother side ofdishwasher.
HeJpfuJ
Tip:Push u ponfront o fdishwasher
toraise d ishwasher
offthe ground toadjust front l egs. With some i nstallations,
it
may beeasier toadjust thefront l egusing t he 3A6" hex head
socket oradjustable
wrench.
Place l evel against topfront o pening oftub. C heck
that d ishwasher
islevel from side toside. Ifdishwasher
isnot
level, adjust front l egs upordown until d ishwasher
islevel.
Connect
to Water Supply
Be sure rubber washer
is properly seated in fitting. Slide the 3/4"
fitting up to the valve and hand tighten
to avoid unintentional
cross-threading.
Hand tighten
until the coupling
is tight. Using
pliers, check the tightness
of the coupling.
An additional
1/4to 1/2
turn may be required to seal the rubber gasket.
NOTE: Do not overtighten.
Damage
to the coupling
can result.
Place paper towel
under 90 ° elbow fitting. Turn on water
supply
and check for leaks. If leak occurs,
repeat previous
step.
If needed, see website
for animated
representation
of this step. Visit www.whirlpool.com/watersupply
under
FAQ tab.
NOTE: Do not use Teflon _>ttape with compression
fittings.
1- _TEFLON
is a registered
trademark
of E.I. Du Pont
De Nemours
and Company.
15

Advertisement

loading

This manual is also suitable for:

Plastic giant tub dishwasher