Whirlpool 24-Inch - Built-In Dishwasher (Color: Silver) Energy Installation Instructions Manual page 12

Ifneeded, see website f oranimated representation ofthis step.
Visit w ww.whirlpool.com under FAQ tab.
Tighten strain relief screws tosecure cord.
0
Place wires inside t erminal box. Insert tabs on
left s ide ofcover. Make s ure wires are tucked i nside b ox. Close
cover ensuring wires a re notpinched. Use 1/4" nutdriver and
previously removed screw tosecure cover.
NOTE: Donot p lug intooutlet until i nstructed.
Determine Cabinet Opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed (you will
need to measure the lowest point on the underside of the
countertop and the highest point on the floor). Refer to
"Dishwasher Height Adjustment Chart" for wheel position and
the number of turns needed.
Dishwasher Height Adjustment
Cabinet I Wheel Number of turns
opening height position on front leg
I
33% (86.0cm) Removed All the way up
I
34 (86,4 cm) ! 1 . 10
34!/4'i (8710 cm)2
NOTE: If the minimum cabinet opening height is less than 34"
(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to fit into a 337/8"
(86 cm) high cabinet opening, but the dishwasher will be more
difficult to move. (Measurements are approximate. Wheels and
legs are preset at the factory for 341/2'' [87.6" crn].)
Adjust wheels and legs
Turn both leveler legs to the same height. Put wheels in the
required position determined from "Dishwasher Height
Adjustment Chart." (To change wheel position, use a flat-blade
screwdriver to pop out the wheel, then snap into the new
position.)
12