PLACING DRYER IN OPERATION
After the dryer has been properly
installed,
there are a few steps required
before the dryer is ready
for operation.
CS & PS MODELS
(COIN OPERATED)
CS/PS models are activated
by a coin slide.
Install the coin slide (not provided
with product)
as follows:
First, remove the coin slide actuator
from
accessory
package
that is found in the
coin box.
Two (2) screws from the package
attach
the actuator
bracket to the coin slide.
PS MODELS
ONLY refer to PD set-up instruc-
tions for selecting
coin slide option "ON", and
for other set-up options.
DISCONNECT
ELECTRICAL
SUPPLY.
1. Remove
the service door from control
center.
ACCUMULATIVE
More Than One Coin Slide Actuation
-
To accumulate,
this mechanism
can be set
up for one, two or three actuations
of the
slide.
The maximum
amount
of time which
can be accumulated
is 60 minutes.
This
must be done at the start of the cycle to
insure the correct time has been
accumulated.
HOW IT WORKS
When the slide is pushed
in, the coin slide will
move the actuator
arm inward, pivoting
the
switch actuator.
This in turn moves the switch
actuator
arm towards
the timer shaft.
SLIDE
CONTACTS
HERE
.
Using a driver, unscrew the bolt (located
in
control center) from retainer in from face of
the control center.
3. Install the actuator
bracket to the coin slide.
4. Insert the coin slide into the control center
and thread
retaining
bolt into slide housing.
ACTUATOR
ARM
SWITCH
ACTIVATOR
ARM
SWITCH
ACTUATOR
As the slide continues
to be pushed
inward it
will contact the index wheel driver releasing the
index wheel.
The index wheel return spring will
rotate the index wheel in a counterclockwise
direction.
It will continue
rotating
until the
switch actuator
arm catches
a movable
return
stop.
This stops the rotation of the index wheel
for the first slide actuation.
INDEX
NOTE:
Some coin slides may require
breaking and removing the tab on
the actuator bracket.
INDEX
WHEEL
DRIVE
/
k
|
r
ACTUATOR ROD
SWITCH BRACKET IS ADJUSTABLE
TO ACCOMMODATE
ANY COIN SLIDE.
5. On PS models, make certain short leg of
ACTUATOR
ROD is inserted through
slot in
the actuator
bracket.
6. Reinstall
service access door.
TIME ADJUSTMENT
INSTRUCTIONS
-
CS ONLY
This timing mechanism
can be either
accumulative
or nonaccumulative.
When
shipped,
the dryer will be set up for
nonaccumulative
operation
with the time adjust-
ment peg in position
"C".
NONACCUMULATIVE
One Coin Slide Actuation
-
Refer to charts for information
on various
times available
and set-up instructions.
MOVABLE
RETURN
STOP
During the second coin slide actuation,
the
switch actuator
will move into position and the
index wheel will continue
rotating as described
in the previous actuation.
It will continue
rotating
until either the switch actuator
arm
catches
a second movable stop or the index
wheel timing lug contacts
the timer bracket tab.
TIMER
BRACKET
TAB
INDEX
WHEEL
TIMING
LUG
When a second
movable
stop is used, a third
actuation
of the side is possible.
The third
actuation
will allow rotation of the index wheel
counterclockwise
until the index wheel timing
lug contacts
the timer bracket tab.
Once the
timing lug contacts
the bracket tab, no
additional
drying time can be obtained.