Getting Started; Canceling The Display Demonstration; Setting The Demonstration Mode; Adjusting The Clock - Kenwood KDC-3051M Instruction Manual

Getting started

Canceling the display
demonstration
The display demonstration is always turned
on unless you cancel it.
When you turn on the power (or after you
reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \
[VOLUME KNOB]
1 Press the volume knob.
[YES] is selected as the initial setup.
2 Press the volume knob again to confirm.
[DEMO OFF] appears.
If no operation is done for about
15 seconds or if you turn the volume knob
to select [NO] in step 2, [DEMO MODE]
appears and the display demonstration
starts.

Setting the demonstration mode

1 Press the volume knob to enter
[FUNCTION].
2 Turn the volume knob to select
[DEMO MODE], then press to enter.
3 Turn the volume knob to select [ON] or
[OFF].
If [ON] is selected, display demonstration
starts if no operation is done for about
20 seconds.
4 Hold to finish the procedure.
Item
PRESET TYPE NORM *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ MW/ LW/ SW1/ SW2). ;
MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ MW/ LW/
SW1/ SW2).
KEY BEEP ON */ OFF: Activates/deactivates the keypress tone.
TDF ALARM ON: Activates the alarm if you forgot to detach the faceplate when ACC is set to OFF. ; OFF *: Cancels
RUSSIAN ON: Folder name, file name, song title, artist name, album name are displayed in Russian (if applicable). ;
SET OFF *: Cancels.
P-OFF WAIT Sets the duration when the unit will automatically turns off (while in standby mode) to save the battery.
–––– : Cancels ; 20M *: 20 minutes ; 40M: 40 minutes ; 60M: 60 minutes
[TDF ALARM] is selectable only with KDC-MP249/ KDC-MP2049/ KDC-MP149.
[RUSSIAN SET/ P-OFF WAIT] is selectable only with KDC-3051M/ KDC-315M.
6

Adjusting the clock

1 Press the volume knob to enter
[FUNCTION] mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select [CLOCK],
then press to enter.
4 Press the volume knob to select
[CLOCK ADJ], then press to enter.
Clock hour flashes on the display.
5 Turn the volume knob to adjust the
hour, then press to enter the minute
adjustment.
Clock minutes flashes on the display.
6 Turn the volume knob to adjust the
minute, then press to confirm.
Press 4 / ¢ to move between the
hour and minute adjustment.
7 Hold

Initial settings before operations

1 Press
2 Press the volume knob to enter
[FUNCTION] mode.
3 Turn the volume knob to select
[INITIAL SET], then press to enter.
4 Turn the volume knob to make a
selection, then press to confirm.
See table below for selection.
5 Hold
Selectable setting (Preset: *)
to finish the procedure.
SRC to enter [STANDBY] mode.
to finish the procedure.