Maytag AKT3040 Series Service Manual page 17

Installation Instructions
Junction Box Connection
Junction box is not supplied with cooktop. Junction box
must be U.L. or C.S.A. listed and meet NEC and Mobile
Home Manufactures Association Standards.
• Three-wire conductor junction box allowed for residental
usage in United States.
• Four-wire conductor junction box required in Canada
and for most mobile home installations, but can be
used for residental.
• Refer to local, municipal, and stae building codes.
NOTE: A power cord must not be used.
Red House
Wire
Black
House Wire
Red
Cooktop Wire
Black
Cooktop Wire
3 - Wire Electrical Installation
United Sates Only
Red House
Wire
Black
House Wire
Red
Cooktop Wire
Black
Cooktop Wire
4 - Wire Electrical Installation
United States or Canada
©2003 Maytag Appliances Company
Notice To Installer
Follow accompanying instruction carefully.
Preparation Of Countertop
The cutout in the countertop into which the appliance is to
be installed should be prepared according to the cutout
dimensions given on page 1 of these instructions.
White
House Wire
Installation Of Appliance
White
1. Remove the cooktop from the carton and place it
Cooktop Wire
Green
Cooktop Wire
2. Provide cutout in countertop.
3. Place unit in the cutout.
4. Make electrical wire connection to unit. Consult local
5. Test to insure control knobs operate all elements
Refer to the following Installation Instructions for
detailed information on installing units.
• AKT3040* and AKT3640* – 8101P469
Green
House Wire
• CEC1430AA, CEC1536AA, JEC7430AA, and
White
House Wire
• JEC8430AD, JEC8536AD – 8101P503
• JEC9530AD, JEC9536AD – 8101P495
White
• MEC5430BD and MEC5536BA – 8101P478
Cooktop Wire
Green
Cooktop Wire
16022159 Rev. 0
!
CAUTION
Never use a metal blade to pry knob off. If knob cannot
be easily removed, tuck folds of a dish- towel under
knob skirt and pull upward with steady, even pressure.
!
CAUTION
Cutout dimensions are critical. Dimensions must be
measured and cut accurately to within + 1/16" (.16 cm)
to insure proper fit.
upside down over two soft pads making sure control
knobs do not interfere with any surface.
codes for proper power hook-up.
properly.
MEC4430BD – 8101P480
A–3