Table of Contents
Advertisement
Connecting the Display
Connecting with the PC equipment
1.
Before setting up the monitor, ensure that the power to the monitor, the computer
system, and other attached devices is turned off.
2.
Connect signal input cable
of the signal cable.
A
Connect D-SUB Cable
B
Connect DVI-D Cable
NOTE
This is a simplified representation of the rear view.
This rear view represents a general model; your display may differ from the view as shown.
User must use shielded signal interface cables (D-sub 15 pin cable, DVI cable) with ferrite cores to maintain
standard compliance for the product.
Varies according to model.
Wall-outlet type
3.
Press
When monitor power is turned on, the 'Self Image Setting
Function' is executed automatically.
(Only Analog Mode)
NOTE
' Self Image Setting Function'? This function provides the user with optimal display settings.When
the user connects the monitor for the first time, this function automatically adjusts the display to
optimal settings for individual input signals.
'AUTO' Function? When you encounter problems such as blurry screen, blurred letters, screen
flicker or tilted screen while using the device or after changing screen resolution, select AUTO
function to improve resolution. (Only Analog Mode)
1
and power cord
button on the front switch panel to turn the power on.
2
in order, then tighten the screw
When using a D-Sub signal input cable connector
for Macintosh
Mac adapter : For Apple Macintosh use, a
separate plug adapter is needed to change the
15 pin high density (3 row) D-sub VGA
connector on the supplied cable to a 15 pin 2
row connector.
9
Connect the signal
input cable and
tighten it up by
turning in the
direction of the
arrow as shown in
the figure.
Advertisement
Table of Contents
