Table of Contents
Advertisement
General Care & Cleaning
When lowering the cooktop, grasp the sides with fingertips only. Be careful not to pinch fingers. Also, DO NOT
drop or bend the cooktop when raising or lowering. This could damage the surface.
DO NOT turn the burners on when the cooktop is raised for cleaning. Be sure that the top is completely lowered
and securely in place before turning on the burners.
To Raise and Lower the cooktop
for Cleaning
1.
Remove burner grates and drip pans (some models). Set aside.
2.
Grasp the sides of the cooktop and then lift from the front (See Fig. 1)
3.
Lift the cooktop high enough to allowthe cooktop support
rods to snap into place. The rods will support the cooktop in the
raised position.
4.
Clean underneath using hot, soapy water and a clean cloth; then, dry.
5.
To lower the cooktop, grasp the front corner of each side of the top while pushing back on each rod with the heel of your
hand. This will release the notched support. Hold the range top and gently slide the cooktop down to the range.
Cooktop
Cooktop support rods
Support
Bar
Fig. 1
Fig. 2
Removing
and Replacing
Surface
Burners
for Cleaning
To Remove Burners
1.
Remove surface burner mounting screws with a Phillips-head screwdriver. See Fig. 2 for screw locations.
2.
Tilt the burner at the end closest to the support bar until the Iocator tab is released (front burners tilt right, rear burners tilt
left). Move the burner toward the back of the range. This will separate it from the gas valve at the front of the range.
To Replace Burners
1.
__idetheburnertube_verthegasva_veatthefr_nt_ftherange(fr_ntburnersfit_vertherightva_ve,
rearburnersfitoverthe
left valve on each side of the range).
2.
Tiltburnersothatthelocatingtabwillslideintotheslotonthesupportbar.
Make sure burners are properly seated on support
bar and are level.
3.
Replace mounting screws.
12
Advertisement
Table of Contents
