Cleaning The Spark Arrester - Yamaha TTR250V(C) Owner's Manual

CAUTION:
G
Make sure that the air filter ele-
ment is properly seated in the
air filter case.
G
The engine should never be op-
erated without the air filter ele-
ment installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
8. Install the panel.
PERIODIC MAINTENANCE AND MINOR REPAIR
ECA10480

Cleaning the spark arrester

The spark arrester should be cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
NOTE:
Make sure to select a well-ventilated
area free of combustible materials to
clean the spark arrester.
1. Remove the tailpipe by removing
the bolts, and then pulling it out of
the muffler.
1
(×3)
1. Bolt
2. Tap the tailpipe lightly, and then
use a wire brush to remove any
carbon deposits from the spark ar-
rester portion of the tailpipe and in-
EAU21241
1. Tailpipe
2. Spark arrester
NOTE:
Make sure to align the bolt holes when
inserting the tailpipe.
6-13
side of the tailpipe housing.
1
2
3. Insert the tailpipe into the muffler,
and then install and tighten the
bolts.
4. Remove the purging bolt.
2
3
4
5
6
7
8
9