Warming Up Engine; Manual Start And Electric Start Models; Shifting; Forward (Tiller Handle And Remote Control Models) - Yamaha F115 Owner's Manual

return the main switch to "
10 seconds, then crank the engine
again.
EMU27670

Warming up engine

EMU27710
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure warning in-
dicator goes off after starting the engine.
3. Check for a steady flow of water from the
cooling water pilot hole.
ECM00210
CAUTION:
If the low oil pressure warning indicator
G
does not go off after the engine starts,
stop the engine. Otherwise serious en-
gine damage could occur. Check the oil
level and add oil if necessary. Consult
your Yamaha dealer if the cause for the
low oil pressure warning indicator can-
not be found.
A continuous flow of water from the pi-
G
lot hole shows that the water pump is
pumping water through the cooling
passages. If water is not flowing out of
the pilot hole at all times while the en-
gine is running, overheating and seri-
ous damage could occur. Stop the
engine and check whether the cooling
water inlet on the lower case or the
cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
" (on), wait
EMU27740
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM00220
CAUTION:
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the
engine idles (or runs at low speeds).
EMU27764
Forward (tiller handle and remote
control models)
Tiller handle models
1.
2.

Shifting

WARNING
Place the throttle grip in the fully closed
position.
Move the gear shift lever quickly and
Operation
ZMU04229
45