Lubrication (Except Oil Injection Models); Cleaning And Anticorrosion Measures; Cleaning The Outboard Motor - Yamaha F2.5 Owner's Manual

Maintenance
ECM00300
CAUTION:
Do not run the engine without supplying it
with cooling water. Either the engine water
pump will be damaged or the engine will
be damaged from overheating. Before
starting the engine, be sure to supply wa-
ter to the cooling water passages.
ECM00290
CAUTION:
If the fresh water level is below the level of
the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
6. Cooling system flushing is essential to
prevent the cooling system from clogging
up with salt, sand, or dirt. In addition, fog-
ging of the engine is mandatory to pre-
vent excessive engine damage due to
rust. Perform the flushing and fogging at
the same time.
EWM00090
WARNING
Do not touch or remove electrical parts
G
when starting or during operation.
Keep hands, hair, and clothes away from
G
the flywheel and other rotating parts
while the engine is running.
7. Run the engine at a fast idle for 10–15
minutes in neutral position.
8. Just prior to turning off the engine, quickly
spray "Yamaha Stor-Rite Engine Fogging
Oil" (Part No. LUB-STRRT-12-00) alter-
nately into each carburetor or the fogging
hole of the silencer cover, if equipped.
When properly done, the engine will
smoke excessively and almost stall.
9. Remove the outboard motor from the test
tank.
33
10. Drain the cooling water completely out of
the motor. Clean the body thoroughly.
11. Install the silencer cover/cap and top
cowling.
EMU28400
Lubrication (except oil injection mod-
els)
1. Grease the spark plug threads and install
the spark plug(s) and torque to proper
specification. For information on spark
plug installation, see page 36.
2. Change the gear oil. For instructions, see
page 42. Inspect the oil for the presence
of water that indicates a leaky seal. Seal
replacement should be performed by an
authorized Yamaha dealer prior to use.
3. Grease all grease fittings. For further de-
tails, see page 36.
EMU28421

Cleaning and anticorrosion measures

1. Wash down the exterior of the outboard
motor with fresh water and dry off com-
pletely.
2. Spray the outboard motor exterior with
"Yamaha Silicone Protectant" (Part No.
LUB-SILCNE-13-00).
3. Wax the cowling with a non-abrasive wax
such as "Yamaha Silicone Wax" (Part No.
ACC-11000-15-02).
EMU28450

Cleaning the outboard motor

After use, wash the exterior of the outboard
motor with fresh water. Flush the cooling sys-
tem with fresh water.