Maintenance; Brush Cleaning And Maintenance; Motor Replacement & Grooved Belt Tensioning - Windsor IM Operator Instructions Manual

Maintenance

Brush Cleaning And Maintenance

After each session of carpet cleaning, the brushes
and the brush housing should be cleaned. Before
cleaning or changing the brushes, always unplug the
machine from the power supply.
Brushes are removed without tools. After handle is in
locked position, tilt the machine back and rest on
handle. To release brush from spring clip pull spring
clip away from brush end cap. Lift brush out of
machine.
The brushes may be soaked in warm or hot water
using mild detergent, and then rinsed with warm
water.
NOTE: Brushes with crushed bristles can often be
restored to original condition by soaking in hot
water.
Keep brushes clean and free from debris. Rotate
brushes after every use as this will increase the life
span of the brushes and ensure even wear.
Before reinstalling brushes, clean out machine brush
housing and hopper by wiping with a clean damp
cloth.
Motor Replacement & Grooved Belt
Tensioning
1. Disconnect machine power supply.
2. Detach quick disconnect hose from top of
solution tank. (Deluxe Only)
3. Remove elastic straps and solution tank. (Deluxe
Only)
4. Remove two dome screws and dome assembly.
CIRCUIT BREAKER
& BOOT
WIRING GROMMET
5. Remove the circuit breaker boot and push the
circuit breaker clear of cover.
14
NOTE: All directions mentioned in this manual are
from the operator's point of view.
6. Mark left and right on the lift cams.
7. Remove the two cam bolts. This will also free the
NOTE: There are four plastic bushings that the
handle pivots on, leave them on the motor clamps.
LIFTING CAM
RIGHT
8. Remove the handle assembly.
9. Unscrew the wiring grommet from the main
10. Remove the the front and back screws and move
NOTE: The handle assembly and cover are still
attached to the frame by wiring. Be careful not to
pinch wiring when reassembling.
11. Remove the (2) plastic finger guards.
12. Mark the tension set screws for reference when
DOME
COVER
86269870 CARPET MAINTAINER
lift cams.
RIGHT SIDE
cover, and set retaining bracket and screw aside.
the main cover to the side.
reassembling.
MOTOR CLAMP
LIFT BRACKET
MOTOR
PLASTIC FINGER
GUARD (2)
LIFTING CAM
LEFT
LEFT SIDE