DATA LOG/OVERVIEW MODEL _______________________________________ DATE OF PURCHASE __________________________ SERIAL NUMBER ______________________________ SALES REPRESENTATIVE # _____________________ NAME: __________________________________________________________________________________________________ ADDRESS: _______________________________________________________________________________________________ PHONE NUMBER: _______________________________________________________________________________________ The Carpet Maintainer is designed to maintain carpet using the Quick Dry Carpet Care System. The machine has two counter rotating brushes that scrub chemical into the carpet.
Data Log/Overview..2 Table of Contents...3 HOW TO USE THIS MANUAL How to use this Manual...1-1 SAFETY Important Safety Instructions ...2-1 Hazard Intensity Level..2-2 Grounding Instructions...2-3 Safety Label Location ...2-4 OPERATIONS Technical Specifications..3-1 How the Machine Works..3-2 Machine Operation...3-3 Pre-run Inspection.
HOW TO USE THIS MANUAL This manual contains the following sections: HOW TO USE THIS MANUAL SAFETY OPERATIONS MAINTENANCE PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts. Parts may be ordered from authorized dealers.
SAFETY IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. WARNING: To reduce the risk of fire, electric shock, or injury: Connect to a properly grounded outlet. See Grounding Instructions. Do not leave the machine unattended.
SAFETY HAZARD INTENSITY LEVEL T he following symbols are used throughout this guide as indicated in their descriptions: There are three levels of hazard intensity identified by signal words -WARNING and CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definitions: WARNING - Hazards or unsafe practices which could result in severe personal injury or death .
THIS PRODUCT IS FOR COMMERCIAL USE ONLY. ELECTRICAL In the USA, this machine operates on a standard 15 amp 120V, 60 hz, A.C. power circuit. The amp, hertz, and voltage are listed on the data label found on each machine. Using voltages above or below those indicated on the data label will cause serious damage to the motors.
SAFETY SAFETY LABEL LOCATION The following WARNING LABEL(S) are found on your cleaning unit. These labels point out important Warnings and Cautions which should be followed at all times. Failure to follow warnings and cautions could result in fatality, personal injury to yourself and/or others, or property damage. Follow these instructions carefully! DO NOT remove these labels.
4. No dwell time is required. Do not allow chemical to dry before brushing. 5. Brush treated area to emulsify soils using the Windsor iCapsol or other carpet- brushing machine. 6. Allow to dry until dry to touch (approximately 20 minutes) before opening area to traffic.
Move the machine in multiple directions and overlapping strokes. For best results use Windsor iCapsol or Prochem ProCaps products. STARTING MACHINE – DELUXE NOTE: Perform pre-run machine check before operating machine.
OPERATIONS TRANSPORTING A SPRAYER 1. This machine has the capability to mount a small pump-up sprayer. TRANSPORTING CHEMICAL - DELUXE 1. This machine has the capability to mount chemical bottles or trigger sprayers to the back of the solution tank. WARNING This Machine is not intended to carry more than 30 pounds.
MAINTENANCE BRUSH CLEANING AND MAINTENANCE After each session of carpet cleaning, the brushes and the brush housing should be cleaned. Before cleaning or changing the brushes, always unplug the machine from the power supply. Brushes are removed without tools. After handle is in locked position, tilt the machine back and rest on handle.
PROBLEM No power to machine Electrical Shock Nuisance tripping of circuit breaker Brush not turning or scrubbing Power to motor but motor does not Bearing squealing or grinding in brush housing Machine will only run if the green (on) switch is continuously held down No flow or uneven flow from jet (Deluxe only) Weak flow from clean jet...