Hunter 41462-01 Installation And Operation Manual page 9

For Angle Mounting Only: Be For Angle Mounting Only For Angle Mounting Only
For Angle Mounting Only For Angle Mounting Only
sure to orient the ceiling plate so
that the arrows on the plate point
up towards the ceiling peak as
shown in Figure 2b.
Figur Figur Figur Figur Figure 2b - Corr e 2b - Corr e 2b - Corr e 2b - Corr e 2b - Correct Position of Ceiling ect Position of Ceiling ect Position of Ceiling ect Position of Ceiling ect Position of Ceiling
Plate for Angle Mounting Plate for Angle Mounting Plate for Angle Mounting Plate for Angle Mounting Plate for Angle Mounting
41462-01 10/14/2005
5. Place a flat washer on each of the
two 3" screws and pass the screws
through the slotted holes in the
ceiling plate as shown in Figure
2c.
6. Tighten the screws into the 9/64"
pilot holes; do not use lubricants
on the screws. Do not over-
tighten.
Ceiling Joist
2 x 4 Brace
Ceiling
Plate
Outlet Box
Flat
Washer
3" Wood
Screw
Figur Figur e 2c - Attaching Ceiling Plate to e 2c - Attaching Ceiling Plate to
Figur Figure 2c - Attaching Ceiling Plate to Figur e 2c - Attaching Ceiling Plate to e 2c - Attaching Ceiling Plate to
2 x 4 Brace 2 x 4 Brace 2 x 4 Brace
2 x 4 Brace 2 x 4 Brace
®
Ceiling
9